2016/7/19 9:01:29
LOOPS in leadcore take seconds to splice and will allow you to make your own leaders rather than buying pre-tied versions or trying to tie leadcore to nylon which is more difficult and leaves a bulky knot. Here’s how you do it…
1 Snip cleanly through the end of your length of leadcore with sharp scissors. Pull back the polyester outer to expose around three inches of inner lead wire. It’s easily done with finger and thumb.
2 Snip the wire off, then ‘push’ the bunched up polyester outer back into position so you have a hollow length of three inches of material. Removing the lead wire is fine, leadcore’s breaking strain comes from the outer.
3 Push a fine splicing needle into the fibres of the polyester where the lead wire ends. Don’t push so hard you come straight out the other side. Once you’ve got the tip in, gently push the needle lengthways down the centre.
4 Once the needle has been pushed an inch or so along the hollow centre of the polyester, poke it back out the side of the leadcore and trap the very end of the leadcore in the lip close of the needle.
Catch More Fish With These Great Fishing Tips
Do you still remember the time when you caught your first fish? Was it on at local fishing hole wi
Tips And Tricks For Your Fishing Trip In Dubai
These fishing techniques will help you not only to catch fish, but other under water creatures such
Sacred Spain: Art And Belief In The Spanish World Now At The Indianapolis Museum Of Art
The music sounded superior, and the crowd here was very quiet, though there were hundreds inside at
Contact management E-mail : [email protected]
Copyright © 2005-2016 Outdoor sports All Rights Reserved