QuestionI just installed a new Minn Kota Edge trolling motor (65 # thrust) and I cant get it ti stow properly. When I lay it down it will stow, but it is bends the shaft. I've tried moving the shaft, making it shorter, longer, but it still wont lay flat.
AnswerDavey, Contact your dealer where you bought the motor. If he will not give you service contact the company directly giving them the details of what is happening. It could be that it is installed improperly or something was damaged in shipment or quality control at the factory screwed up. Do not give up until they make it good.
If you continue to have problems getting it taken care of contact me again and I will see if I can revive Mrs. Johnson the CEO of Johnson motors who make the Minn-Kota.
I had a problem with mine and couldn't get anything done but when I found her address and mailed her directly it was quickly taken care of.
If you can't get it taken care of give me an e-mail and I will see what I can do.
I am
Jack L. Gaither
[email protected]
Davey, for some reason I got this back. I don't know if you got it or not so I am resending it. If you allready have it simply disregard this.
