Replacing bump guard for a boat

2016/7/16 9:27:49

Question
I am needing info. on where to buy 1 3/4" x 2" bumper guard in a 30' length for a 1955 Viking boat.

Answer
I WOULD CONTACT VIKING BOAT MANUFACTURER FIRST. I AM ASSUMING YOUR TALKING ABOUT THE RUBRAIL. FOR A 1955 BOAT THIS MAY NO LONGER BE AVAILABLE. THE NEXT BEST THING IS TO GO TO WEST MARINE OR A BOATING CENTER AND LOOK IN THEIR CATALOGUES FOR RUB RAILS AVAILABLE THAT YOU COULD USE.

HOPE THIS HELPS BRUCE

Prev:Mercruier fuel pump
Next:wireing

Related Articles: Evinrude moter wont start; 1989 Sea Ray; 25 hp Yamaha Outboard; overheating; wrong fuel mix; Power Trim/Tilt; Boat Peformance; high moisture level; sunk boats

More Great Links

Kayaking the Niagra

QuestionHello Jim, As an expert in kayaks I hope you can point me in the right direction. &nbs

throttle

Questionhi i have a 1990 bayliner capri at full throtte i lose power but if i back it off a bit

MerCruiser Tune Up

QuestionRecently, I had a tune-up and oil change performed on my 1994 SeaRay 330 Sundancer. &nb